To drill guillotine using a radial drill, you need to consider specific steps and tips so that both work is carefully and safety. Giotine's jaw is usually made of steel or hard metals and therefore requires the right tools and techniques. Radial Drill Due to its flexibility and adjustable arm and column, it is a good option for large and heavy drilling such as guillotine jaws
Giotine jaw drilling steps with radial drill:
Select the right drill:
Use titanium. These drills are more resistant to wear and heat.
Choose the drill diameter based on the size of the hole.
Set the device:
Cut guillotine jaw on the radial drill desk. You can use special clamps or fixtures to keep the piece not move while working.
Set the height of the column and the drill arm position to place the drill just above the point that is to be pierced.
Set the spindle rotation speed based on metal material and drill diameter. For steel, low to medium speed (eg 300-600 rpm depending on the size of the drill) is suitable.
Hole Mark:
Mark the exact location of the hole on the guillotine jaw using the ruler and punch. Pigging helps the drill not start.
Use Lubricant:
To reduce heat and extend the life of the drill, use cutting oil or metal lubricant during drilling. This is especially essential for hard metals such as steel.
Cornering:
slowly lower the drill to the piece and start drilling with gentle pressure. Excessive pressure can break the drill or damage the device.
If the hole is deep, raise the drill a few millimeters to remove the trim and cool the drill.
Case Control:
After completing the drilling, check the dimensions and depth of the hole with the measurement tool (such as a caliper) to make sure it matches your needs.
Important Tips:
Safety: Use protective glasses and safety gloves, as sharp and hot metal scraps can be dangerous.
Selection of the right radial drill:
Mark the exact location of the hole on the guillotine jaw using the ruler and punch. Pigging helps the drill not start.
Use Lubricant:
To reduce heat and extend the life of the drill, use cutting oil or metal lubricant during drilling. This is especially essential for hard metals such as steel.
Cornering:
slowly lower the drill to the piece and start drilling with gentle pressure. Excessive pressure can break the drill or damage the device.
If the hole is deep, raise the drill a few millimeters to remove the trim and cool the drill.
Case Control:
After completing the drilling, check the dimensions and depth of the hole with the measurement tool (such as a caliper) to make sure it matches your needs.
Important Tips:
Safety: Use protective glasses and safety gloves, as sharp and hot metal scraps can be dangerous.
Selection of the right radial drill:
for guillotine jaw, which is usually a heavy and large piece, a long -range radial drill (eg 120 or 160 cm) and sufficient power (eg drill up to 50 mm in diameter).
Check the status of drill: the drill must be sharp; Slow drills increases pressure on the device and reduces accuracy.
Radial Drill Application in this case:
Radial drill is very suitable for drilling parts such as guillotine jaws that may require holes in different locations. This device allows access to farther points without the need to move the piece, which is a great advantage over column or manual drills.
Check the status of drill: the drill must be sharp; Slow drills increases pressure on the device and reduces accuracy.
Radial Drill Application in this case:
Radial drill is very suitable for drilling parts such as guillotine jaws that may require holes in different locations. This device allows access to farther points without the need to move the piece, which is a great advantage over column or manual drills.