Montta Destitah Khum, but
Assembly of the bending machine:
Check Maps and Instructions:You must first read the technical maps and manufacturer of the device. These maps include details, location, and how they are connected.
Parts Preparation:
All required components (such as jaws, rollers, main body, hydraulic or electrical system, engine, etc.) Check to make sure they are healthy and complete.
Main body installation:
The body or chassis of the device is installed as the main base. This section should be on a smooth, solid surface to maintain the balance of the device.
assembly of the propulsion system:
Depending on the type of device (manual, hydraulic, electrical or CNC), the propulsion system ( It is installed like an electric motor, hydraulic pump or jacks. Mechanical and electrical connections should be done carefully.
Installation of jaws or rollers:
jaws (for sheet bending) or rollers (for pipe and profile bending). These components must be precisely adjusted so that the bending angle is correct.
Control System Connection:
If the device has numeric control system (NC or CNC), control unit, display and The sensors are installed and calibrated. The wiring should be done according to the standard.
Initial testing and testing:
After assembly, all connections (mechanical, hydraulic and electrical) are checked and the device is tested testing to perform its performance. Test.
Final settings and calibration:
bending angles, pressure and speed of the device are adjusted to comply with the working needs.